Check if the limits are properly set.
Genie garage door only goes down a few inches.
The transmitters remotes will not work to close the garage door.
Try to lower the door.
The garage door can be operated manually by disconnecting the garage door opener from the door using the red pull cord.
Adjust the limits as needed.
My garage door opens about six inches and stops i press the button twice so it will stop going down and then is goes up another 6 inches or so.
It will make troubleshooting later much easier.
Remember that sometimes a garage door opener can increase the binding in a door just because of the way it pushes the door down.
I have a genie is isl ims series garage door.
Make sure only the safe t beams that came with this garage door opener are installed.
For most doors a complete rotation of the screw allows the door to advance 2 inches.
Try to operate the garage door manually this helps you determine if the problem is related to the door or the motor.
Check if the safe t beams red led light.
Genie garage door only moves a few feet and stops and when you push the button again it moves a few inches or a foot down.
You will find that the door will only move an inch or so in the close direction and reverse.
The problem is either due to a blocked path between the sensors dirty eyes loose wires at the sensors or at the motor head or just bad sensors.
You push the button to close the garage door.
If it is a new installation check the postion of the door arm.
Ever notice how it is easier to pull a wagon over a curb than it is to push it.
This just started a couple weeks ago.
Garage door starts down then stops and goes back up or safe t beam system malfunction.
In fact you really should read the entire garage door repair article.
My garage door will open only a few inches and then stops.
Clicking the remote at that point just closes it.
It goes partway down reverses direction and goes back up again.
If the door is working properly it should be easy to lift by hand.